Pro-v (aerocool) - Phoenix Manufacturing Inc.

KEY PRO-V BENEFITS

Variable speed motor

Less noise as the motor will slow down as the temperature reaches the set point.

Higher evaporative efficiency when the motor slows down because the speed of the air through the media will decrease, thereby increasing evaporative efficiency. This results in cooler air being delivered to the space.

AEROCOOL PRO FEATURES

The pro series by aerocool cools better and requires less maintenance than conventional coolers.

PRO-4X4 MEDIA
Pro Series can deliver colder air than any other home comfort evaporative cooler.
PRO-ARMOR
The premier single inlet cooler with polymeric inner structure that completely shields the wet section from corrosive interaction.
RELIABLE LOW SUMP PUMP
This powerful low sump pump keeps your pads wet even when your sump runs low.
FLOMATE
Flomate-quality water distribute on system improves wet out for more efficiency.
PRO-CLEAN SYSTEM
Drains and washes the unit daily and can save as much as 3,000 gallons of water a month as compared to standard bleed-off system.
MIRROSCOPICTM BLOWER SHAFT FINISHING PROCESS
This yields a 90% improvement over the industry standard “ground finish”. This means quieter opera on and longer bearing and shaft life for your cooler!
FACTORY INSTALLED VARIABLE SPEED MOTOR
All components are completely pre-wired by the factory, thus reducing installation time and increasing reliability.
PRO-SHIELD
This weatherizing panel prohibits outward heat loss and cold air from entering into your home during the off-season. Easy to install, media protection is also a afforded thereby increasing the life of the unit.

AEROCOOL® Evaporative Coolers and components are designed and tested in accordance with one or more of the following standards or agencies.

AIR DELIVERY – data published derived from tests conducted in accordance with A.M.C.A. (Air Movement and Control Assoc.) standard 210.

EVAPO- RATIVE MEDIA – Specially Corrugated Cellulose Materials, impregnated with insoluble an rot salts and regidifying saturants.

SEALANT – water immersion per ASTM D870.

FLEXIBILITY – per ASTM D756.

CORROSION RESISTANCE – per ASTM B117.

PENCIL HARDNESS – per ASTM D3363.

IMPACT RESISTANCE – per D2794.

FLEXIBILITY – per ASTM D522. SURFACE BURNING CHARACTERISTICS of building materials (best range) per UL 723 and ASTM E-84. PUMPS recognized under UL standard #778 for operating water pumps with thermal overload and locked rotor protection. POLYMERIC MATERIALS listed in accordance with UL 94 and 746C. MOTORS recognized under UL component standard #1004 for motor certification. MOTORS tested under UL standard #507 for locked rotor and heat rise protection.