Aerocool Trophy Series
Longevity & Low Maintenance
Aerocool Trophy Series
Utilizing single inlet design, the Trophy Series provides the ultimate protection available for the longevity of your cooler. Fully lined in a tough plastic shield, the all-metal construction of the wet module is protected from the damaging effects of typical deposits found in most water systems. High efficiency evaporative cooling, low maintenance and long life of the Trophy Series makes this cooler your award winner.
Responding to your specific requirements, these units are available in three models: down, side and the up discharge for concealed ground level applications.
Choosing the Right Model To Meet Your Needs
Choosing the right Aerocool Trophy Series model is important for proper operation. All Trophy air coolers use efficient Rigid Media and are available in three levels of cooling efficiency.
The Trophy Series air coolers are designed to operate at maximum efficiency with minimal maintenance. The Rigid Media gives the Trophy Series the ability deliver colder air while reducing the time spent replacing standard aspen media.
8” Standard Rigid Media
The 8” media is a good economical choice for high efficiency cooling. It provides increased cooling performance over traditional aspen media pads.
12” Standard Rigid Media
The ultra-efficient 12” media is better choice where maximum cooling efficiency is required.
4×4 Hi Efficiency Rigid Media
The 4×4 Hi Efficient Rigid Media is an 8” blend of high density media combined with standard density media. The result is a highly efficiency rigid media that delivers colder air than any other home comfort evaporative cooler sold today.
Benefits of the Aerocool Trophy Series
High Efficiency Rigid Media The Aerocool® evaporative cooler beats the others cold — it is more efficient and less costly to operate. In fact, it is up to 13% more efficient than conventional coolers. Rigid media material provides cooler air and can last up to 10 times longer than old style aspen pads.
Pro-Armor The polymeric inner structure completely shields the wet section from corrosive interaction, providing long life and worry free operation.
Low Sump Pump The most powerful pump on the market today. US Patent #5,527,157
Easy Access Gravity-Held Doors Easy to remove access doors reduce maintenance time.
MIRROSCOPIC™ Blower Shaft Finishing A PMI Exclusive, This yields a 90% improvement over the industry standard “ground finish”. This means quieter operation and longer bearing and shaft life for your cooler!
Peblar XT Protective Powder Coat Our exclusive Peblar XT surface preparation is the highest quality architectural grade finish used in the industry. This durable multi-layer bonded treatment protects your cooler against corrosion and assures years of reliable service.
Pro-Shield This weatherizing panel prohibits wind and cold from entering into your home during the off-season. Easy to install, media protection is also afforded thereby increasing the life of the unit.
GreenPac Accessory Package Go green with the PMI GreenPac accessory package. This package includes the energy saving Nth Degree Digital Thermostat and the water saving CustomClean Programmable drain cord controller with an extra drain pump.